Start: 10:00

• Played around with the Pad2Pad software.  The last one I did was realtively simple so I had to figure out some of the tricks before drawing this board
• The logical connection tool will auto draw the traces after you set what needs to be connected to what.
• I want to use jumpers for the I2C addressing.  I found the slot, I will have to see where I can find the hardware for that though.
• Drew up the basic parts that need to be included.  Measurements were done so hopefully I can mount the midi and large amplifier boards on standoffs to the board.  I am not sure but I might be able to print it out and see if the holes match up.
• R rotates the piece you are placing.
• Started drawing out the pre-amp circuit on the pad2pad program.  I figured it was best to start with the hardest part so if I have to move anything it won’t be that.

End: 6:00